NTSB: Helicopter Crashed After Rotor Blades Struck Water During Low Turn
The Robinson R44 was filming a powerboating event off Key Biscayne when it went down on November 4.
By Adrian Kovalenko ·

The National Transportation Safety Board determined that a helicopter crashed in Biscayne Bay because its rotor blades struck the water during a low-altitude turn. The agency released this finding in a preliminary report on Wednesday, concluding that the aircraft was flying "extremely" close to the surface.
The incident occurred on November 4 near Bill Baggs State Park off Key Biscayne. The Miami-Dade Sheriff's Office reported that the Robinson R44 II helicopter was on a commercial trip to film a powerboating event offshore at the time of the accident.
The pilot died in the crash, while a photographer and a videographer on board sustained critical injuries. The safety board noted that some of the helicopter's doors had been removed to allow the crew better access for photography and videography. This modification likely contributed to the low flying altitude required for the shoot.
According to the report, the photographer told investigators that the helicopter flew low and parallel to the right side of a boat. The pilot then turned the aircraft to get ahead of the vessel for a specific shot. The videographer observed the rotor blades strike the water during this maneuver, which brought the aircraft down.
Television footage of the scene showed the helicopter upside down underwater. Two yellow emergency floats attached to the bottom of the landing skids were visible. These devices are designed to keep the helicopter afloat during a water landing.
Witnesses in nearby boats made distress calls following the crash. Sheriff Rosie Cordero-Stutz stated that a bystander attempted to assist one of the victims. Rescue workers from local agencies, the U.S. Coast Guard, and U.S. Customs and Border Protection responded to the scene.





